Century Helicopter Products PredatorSE Bedienungsanleitung

Predator 60/ 70SE & Max 9060/70 60/70 SE Max 90DDDDD MAIN BLADES 690mm 700mm 720mmDDDDD MAIN ROTOR SPAN 60.6 in 60.6 in 62.9 inDDDDD TAIL ROTOR

Insert the main gear assembly from the side and slide themain shaft through the upper main shaft bearing block. Alignthe M4 threaded hole with 3mm hol

#HW6017M4x10 SocketScrews &M4x12 Flatwashers x 6Slide the engine assembly in place and install the M4 Socketbolts and washers. Do not locktight th

Install throttle servo to the right side frames. Attach the shortball with M2 thread to the carburetor lever arm with M2 nutand the short steel ball t

The main rotor grips will accept rotor blades that have a rootthickness that is from 12mm to 18mm and have a 5mm hole.Carbon Rotortech and wooden Aero

Looking down on the two tail gears notice that the black gearhas teeth that are in the opposite direction to the silver gear.Make sure the black gear

Press the M4 bearing into the end, slide the M3 thrustbearing (in correct order), micro washer, M3 bearing andlocknut from inside the grip. Use lockti

Insert the M2 threaded rod 10mm into the grey ball link.Slide the end cap over the carbon tube and make a mark,remove and sand the carbon up to this m

Attach the struts (aluminum or carbon) to the main mechanicsusing M3 socket screws, M3x9x3 plastic spacer on the outsideand secure with M3 locknuts on

Assemble the support bridge with M3 hardware. Press eachside onto the support strut and secure with the cable tiewraps provided.Cable Tie x 4SE &

#HI6133WindshieldLeave the protective coating in place until after it is drilledfor mounting screws. Rough cut the windshield leaving 3mm[1/8”] then c

Building Instructions for the Predator series eCCPM helicopter kits.IntroductionCongratulations on your purchase of Century Helicopter Product's

HI6009 COOLING FANHI6020 COOLING FAN SHROUD SETHI6031 CCPM CYCLIC BELLCRANKSHI6032 CCPM ELEVATOR LEVER SETHI6056 MAIN GEAR - 90THI6058B MACHINED TAIL

#HI6153WashoutGuideM3x4 SetScrew#HI6160Rotor HeadBlock#HI6181AHead DampingO-RingsPress in the damping o-rings into the rotor head block.Lubricate with

#HI3176C FlybarControl YokeAssemble each flybar control arm half before it is installed bythreading the double studded ball into the end of the tapere

Install the engine into the mount using the correct number ofshims and ensure that the engine is centered in the mount. Uselocktight on the M4 socket

Attach the clutch shoe with the M3 button socket bolts usingthreadlock.ClutchShoeFanAssemblyClean the clutchbell and inside of the bearing with alcoho

Install the rear ccpm lever into the upper frames flush withthe bearing on the left side, having the mount extend out theright side frame. Assemble th

M3x12SocketScrewAttach two M3x12 Socket screws from the inside of thebattery tray at the forward holes and two M3x10 Socketscrews to the rear holes. A

17mmStandoff x 4Attach the X Frame to the lower side frames first using M3x8Socket screws and locknuts at the lower hole on a flat surface.Attach to t